🌐 中文 (简体) — Community translation View in English

Node Metrics

The node detail screen provides comprehensive telemetry and metrics for each node on your mesh.

设备数据

Basic operating information reported by each node:

公制 说明
电池电量 Current battery percentage
电压 Battery voltage reading
频道利用率 Percentage of airtime consumed
广播时间 Transmission time used by this node
正常运行时间 Time since last reboot

Device metrics are displayed as individual cards with trend sparklines showing battery level, voltage, channel utilization, airtime, and uptime over time.

💡 Tip: Tap any metric card to expand it into a full chart with historical data points. Pinch to zoom the time axis.

传感器指标

Environmental sensor data (requires compatible hardware):

公制 Sensor Examples
温度 BME280, BME680, SHT31
湿度 BME280, BME680, SHT31
气压 BME280, BMP280
气体电阻性 BME680
IAQ (Air Quality) BME680

Environment metrics are charted over time for easy trend analysis — temperature, humidity, and pressure each get their own line chart with the measurement unit displayed on the Y axis.

💡 Tip: Environment metrics require a sensor connected to the remote node. Not all nodes report environmental data. See Telemetry & Sensors for a full list of supported sensors.

信号强度

Radio signal quality information:

公制 说明
SNR Signal-to-Noise Ratio (higher is better)
RSSI Received Signal Strength Indicator (closer to 0 is better)
Hop Count Number of mesh hops for last message

Signal Quality Reference

SNR Range Quality
> 10 dB Excellent
0 to 10 dB 良好
-10 to 0 dB 一般
< -10 dB Poor

电源计量

Power management telemetry (requires INA sensor or compatible hardware):

公制 说明
Bus Voltage Supply voltage
电流 Power draw in milliamps
电源 Calculated wattage

追踪器

Traceroute shows the path a message takes through the mesh:

  1. From the node detail screen, tap Traceroute.
  2. The app sends a traceroute request to the target node.
  3. Results show each hop with SNR/RSSI values.

Reading Traceroute Results 

You → Node A (SNR: 8.5) → Node B (SNR: 5.2) → Target

Each hop represents a relay node that forwarded the message.

定位日志

Historical position data for nodes that share their location:

  • GPS coordinates
  • 海拔高度
  • Speed (if moving)
  • Timestamp for each position report

邻居信息

Shows which nodes a given node can directly hear, useful for understanding mesh topology.

Viewing Metrics

  1. Navigate to Nodes.
  2. Tap the node you want to inspect.
  3. Select the metric category from the detail tabs.

Node detail — local device

The position tab shows location data for nodes that share GPS:

Position inline content

⚠️ Note: Metrics are only available when they have been reported by the remote node. Metrics update at intervals configured on each node’s telemetry settings.